Study for FEA on an underground tank. Septic is the actual cutaway of the underground tank at roughly 1200 gallons.
Roof structure concept
hyperbolic paraboloid
Cost reduction using my approach would be a savings over present methods of 80%. Also if desired the cable network could be left in place or used over and over again to build more of these structures.
Modular Bus/ Fire Truck concept
different size cabs, molded in different configurations using Aluminum bands
(just like an aircraft)
this can be processed in many different ways
Airplane, Land/Sea My 1/4 scale model in development is a function improvement for land sea type aircraft. My plans are to get a kit manufacture to build in full scale. The problems with present sea planes is a high center of gravity. Landing in light crop water conditions can cause the pontoon to dig in and flip the plane. This leaves you hanging by your seat belt with the cabin full of water. This is a drowning situation.
My approach is to have the engine in the body of the plane with a liquid cooled drive train to the prop. This is a highly functional approach and will save lives as well as make this type of land sea plane more desirable. My plans are to complete this model and fly by radio control.Then searching for a kit manufacture to build a full scale test plane.
Hydro at 117 miles per-hour
Concept: control boat rise at high speed (Basically like flying a plane just a few inches above the water)
By Proposing: An Electric Bubble Leveling System, this device would rotate the angle of the stub wings located on both sides of the cockpit not allowing the bow to rise up. This device would make constant minor adjustments for wind as well surface conditions.
While working at the Mercury Test Lab Oshkosh WI (owned by Karl K. at that time) we were attempting to take the world record back. At 117 mph the bow rose up and this hydro became airborne. On its down angle return it broke up in many small parts when striking the water.
Coke dispenser was a joint venture with Graco. My design had an aluminum frame structure with snap on panels which could be injection molded as well as the drip tray and grill.
Enticing the railroad companies to use switch covers to reduce energy, required on all switches in the cold climate areas to change over. I held patents on the approach which was tested and proven to be a large cost reduction in energy use. I sold to a larger composite company and was to stay on with sales and installation training but it all stopped after 9-11.
These are sleds (snowmobile) the picture on the left was a joint venture
The picture on the right is an idea in the works. This will have a light body and hopefully be used in rescue, it will be more cost effective than the hover crafts that are used now.
Design Concept with a Prototype proven dispenser.
Sets on the vanity in a bathroom and sprays at low pressure perfume, deodorant, hair spray, and dispenses face and hand cream.
Quarter turn caps remove for filling.
They also serve for additional air capacity so the small compressor only needs to run for a short period.
Many more concepts and ideas have been patented see them on my blog.